Atlantis Land I-Storm A02-RA(Atmos)_ME01 Manual do Utilizador descarregar pdf (Página 20)

3. Bridge Console commands

3.1 device add

3.1.1 Syntax

device add <device>

3.1.2 Description

This command adds a device to the bridge configuration. Attempts to add the bridge

itself or an existing device to the bridge are rejected.

Attempts to add devices which don’t support the Cyan interface are rejected. There

is a limit on the number of devices that can be attached to the bridge. If the device

being added is from a process which supports multiple devices, the /DEVICE

attribute must be specified as part of the device name. The table below shows

devices which may be attached to the bridge, although not all systems may support

all devices.

Device Remarks Source

Edd Ethernet driver bun_ethernet

r1483 RFC1483 protocol (PVC) rfc1483

Ppp Point-to-Point protocol pp

Configuration saving saves this information. See the section entitled Implementation

Constraints in the ATMOS Transparent Bridge Specification, DO-007087-PS, for

details of which devices are added by default.

3.1.3 Example

Simple examples

device add edd

device add ppp/DEVICE=2

Using the BUN RFC1483 driver

This example shows how to add the BUN RFC1483 driver, dynamically from the

console. You need to define and configure a device and a port.

Normally, the RFC1483 BUN device will pass all data straight through, untouched.

This means that even though you have changed your port definition to include the

RFC1483 driver, you can still use other protocols on the same port. In order to

enable RFC1483 encapsulation, the RFC1483 attribute on the channel must be set to

true.

The channel attribute mode dictates the functional behaviour of the driver, in terms

of encapsulation method to use and traffic nature (bridged/routed). The channel

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 111 112

Sem comentários

Atlantis Land I-Storm A02-RA(Atmos)_ME01 Manual do Utilizador Página 20